Wednesday, December 19, 2012
Cleats II
Cut the cleats, this would have been so much easier if I had a bandsaw especially the small fiddly cuts I will do next.
Time today: 20 minutes
Friday, December 14, 2012
Cleats I
Started working on making cleats. The will be used to secure the halyards on the masts and as mooring cleats on the fore and aft decks.
Found a model on the intranet that I like.
And a piece of oak left over from something.
Drilled holes.
Still need to make the piece trapezoidal (ref drawing above) on the table saw, cut them out and shape them.
Time today: 30min
(p.s this is my post number 200!!!)
Found a model on the intranet that I like.
And a piece of oak left over from something.
Drilled holes.
Still need to make the piece trapezoidal (ref drawing above) on the table saw, cut them out and shape them.
Time today: 30min
(p.s this is my post number 200!!!)
Saturday, December 1, 2012
Foot supports
Decided to glue the foot supports tonight. I have not unpacked the epoxy yet so I used an normal wood glue (vinylacetate homopolymer emulsion stabilised with polyvinylalcohol????) intended for outdoor use. Should be fine as this piece will not be immersed in water, in addition it cures much quicker than epoxy.
Time today: 15 min
Getting ready
Glue applied. Instead of spreading the glue evenly I put the two pieces on top of each other and slid them around a little to make sure I have an even layer of glue.
Pressure applied! Glue is dried within an hour.
Time today: 15 min
First snow
We had the first snow of the season this week. After the weekend apparently it is supposed to get real cold so there may be more.
Sunday, November 25, 2012
Cutting seat
Cut out the foot brace pieces and the rowing seat. Still do not have enough space in the basement so I had to take the workshop outside, a bit cold but at least above freezing.
Did not have time for much more since the kids found a dead fish on the beach and I was needed for the funeral.......
Time today: 30 min
Getting started
All done, next stop is glue (next week?)
Time today: 30 min
Monday, November 19, 2012
Back to the boat
Back to doing some "building" again, even tough the pace will be slower this winter it is nice to focus a little on the boat again. Started to work on the loose pieces for rowing; the seat and the foot support.
The cutting will have to wait until next weekend as I am off on another trip tomorrow.
Time on Sunday: 1h
The sketch
The templates
Drawn up and ready for cutting
Time on Sunday: 1h
Subscribe to:
Posts (Atom)













