Stainless

Got delivery of the stainless stuff today! So I had to fiddle with these a little before getting back to sanding.

Rudder gear

Mast traveller and boomkin fittings (my boomkin will be mounted on top of the aft deck)

From the top: Rudder stopper, center board pin and center board up haul plate

After finishing the sanding I did some cleanup in order to be ready for painting tomorrow.

The rudder gear is a few sizes bigger than specified for this design so I needed to fit a few extra pieces of ply to the transom to have something to bolt them through.

The gudgeon is wider than the reinforcement

Measuring the angles

9 mm reinforcements glued in

Time today: 2h